FOG /SMOKE MACHINES
READ AND SAVE THESE INSTRUCTIONS
FOR HOUSEHOLD USE ONLY

V-930T D.J. FOGGER
1. Carries ETL and TUV/GS safety approval, as well as conforms to E.E.C product safety standard of
“EN-60335”
2. High quality thermostat.
3. High pressure piston pump.
4. Applications: Rentals for auditoriums, School Parties , Social Events, Small Clubs, Mobile D.J.’s
 

SPECIFICATIONS 1. Input power: 120V/60HZ 2. Heater: 1000 Watts 3. Fuse type:120V/10Amps 4. Tank capacity: 1 liter 5. Warm up time: Approximately 5 minutes 6. Fog output: 5,000 cubic feet per minute 7. Unpacked weight: 15lbs., 7kgs. 8. Unit dimensions: 14 “(L) x 8”(W) x 7”(H) IN 370 (L) x205 (W) x295 (H) MM

INSTRUCTIONS FOR THE V-930T D.J.FOGGER
1. Insert remote control into rear of machine.
2. To avoid risk of electric shock, insert line cord plug into grounded outlet only. (Indicator light on the remote controller will come on)
3. Fill reservoir with water based Fog Fluid. Use FJ-1 or FJ-1Q ONLY
4. Close cap tightly.
5. When indicator light on the remote controller goes off, the machine is ready for use.
6. At times the indicator light will come on. This is NORMAL, the machine is simply recycling. Depress the switch only when light is OFF.
7. Allow fog machine to “COOL DOWN” before packing for transportation.

IMPORTANT
ALWAYS MAKE SURE THAT THERE IS ENOUGH FOG FLUID IN THE TANK BEFORE TURNING THE FOG MACHINE ON. ACTIVATING THE PUMP WITHOUT FLUID CAN CAUSE DAMAGE TO THE PUMP AND HEAT CORE.

CAUTION
VAPOR FROM THIS FLUID MAY BE IRRITATING TO SOME PERSONS WITH ALLERGIC SENSITIVITY. DO NOT EXPOSE AT CLOSE RANGE TO KNOWN ASTHMATIC. USE IN A WELL-VENTILATED AREA. TO AVOID INJURY FROM HOT STEAM- KEEP AWAY FROM NOZZLE AT LEAST TWO FEET.

CLEANING
TO INSURE PROPER CARE AND A TROUBLE FREE LIFE FOR YOUR FOG MACHINE, USE THE FOLLOWING FORMULA: USE UNCLOGIT  EVERY 2-4 WEEKS.( DEPENDING ON FREQUENCY OF USE.) THIS SHOULD ALLOW FOR A THOROUGH STEAM CLEANSING. FOLLOW THE SAME INSTRUCTIONS AS WITH THE FOG FLUID, KEEP THE BUTTON DEPRESSED FOR 15-30 SECONDS.